Haha you make a good point
I was just reading the manual about working with the cylinder head etc, seems a bit tricky!
I get it - Lord Of The Rings. hahaha
| CX500 GL500 650 Global https://motofaction.org/motorcycles/honda-cx-gl/shep/ |
|
| Hello from New Zealand! https://motofaction.org/motorcycles/honda-cx-gl/shep/viewtopic.php?f=6&t=567 |
Page 2 of 2 |
| Author: | silentdth [ Sat Jul 03, 2010 2:36 pm ] |
| Post subject: | Re: Hello from New Zealand! |
Haha you make a good point I was just reading the manual about working with the cylinder head etc, seems a bit tricky! I get it - Lord Of The Rings. hahaha |
|
| Author: | Gman [ Sat Jul 03, 2010 2:48 pm ] |
| Post subject: | Re: Hello from New Zealand! |
silentdth wrote: Haha you make a good point I was just reading the manual about working with the cylinder head etc, seems a bit tricky! I get it - Lord Of The Rings. hahaha  Just thought I would add.I threw out one of those,"Push-in" compression testers over 30 years go and have not and never will use one again.They are inaccurate and next to useless IMHO.You need a proper,"Screw-in" one and in our case you have to buy a special 12mm adaptor for the normal supplied ones, This is the Brand over here I use, http://www.halfords.com/webapp/wcs/stor ... yId_165557 Adaptor http://cgi.ebay.co.uk/Gunson-G4055B-Col ... 43a007a18a If short on money best to try and borrow one. |
|
| Author: | silentdth [ Sun Jul 04, 2010 1:06 am ] |
| Post subject: | Re: Hello from New Zealand! |
I am using one of those push-in testers. If only I was in the UK I'd hit the buy now!  
|
|
| Page 2 of 2 | All times are UTC [ DST ] |