A couple of days ago I was lamenting what I thought was the permanent demise of Chopper Charles when I happened upon this site and presto! - all of the CX ninjas from CC seemed to be here aswell. Big relief as I'm in the middle of a carb clean which, without this place, would be almost impossible for a greenhorn like me.
There's a question I have which I'll ask here just in case any of you know and post the question in the relevant section too :-
I would like to follow the advice for replacing the 'hard to get to' screw on the float chamber (the inside one of the three) with a hex screw so would like to know what size/spec I should get?
More importantly, how do I find out for myself - apart from just trying several til one fits - my usual method
